Go to VST connections (press F4) and select the input tab. Large buffer size means high latency so more delay but lower load on ASIO and CPU. Small buffer size means low latency so less delay and better for real time recording but higher load of ASIO and CPU so the risk of audio drop-outs is higher. It has no relevance to the initial setup of the in/output buses in Cubase): You can also set the ‘Audio Buffer Size’ to control latency (you can always change this later depending on what activity you’re performing. Under the advanced tab make sure that at least the in/output ports you are going to use are active.
Here you can set additional options regarding the driver.
#How to setup usb mic on cubase 8 driver
Click on ‘Control Panel’ and the ASIO4ALL driver panel should open.Optionally you can rename the ports for convenience under 'Show as’. Make sure the ‘visible’ box is checked for at least the connections you intend to use. You will now see the available in/output ports. On the left side select the ASIO4ALL driver.Go to Devices > Devices Setup > VST Audio system and use the drop down menu under ‘Audio Driver’ to select your audio interface (ASIO4ALL).We’re going to set up the ASIO4ALL driver and connect a mic (mono) input and a master (stereo) out bus.
I am very happy to finally have the mic working, but I would be very grateful for any help regarding the audio output. However, I have tried both adding Realtek HD Audio Output and removing it in the Control Panel, but this has solved nothing. I have been to Devices > Device Setup > VST Audio System > ASIO4ALL v2 > Control Panel, then selected the USB Mic instead of the inbuilt mic. I’m afraid I’m not used to such complex software, and so far have been unable to solve the problem. I have tested my headphones/in-built speakers using the sampler track keyboard, and again there is silence. However, I am unable to hear anything I have recorded. I have managed to set up a USB Mic thanks to advice given here ( ), and am now able to record audio after downloading an ASIO4ALL Driver. I am new to the Cubase family and am using it to record interviews.
I am having problems with my new Cubase 9 Elements software, and would be most grateful if somebody could offer some advice.